METHOD - silicone baking mat bed insulation and surface adhesion

thingiverse

This appears to be a review and comparison of various 3D printing surfaces, specifically focusing on PEI sheets and buildtak clones from Chinese sellers. The reviewer has tested several combinations of these surfaces with silicone mats, red silicone sheets, and yellow Polyimide-Tape-stickers. They have observed varying levels of success with each combination. Here are the main points from the review: 1. **PEI Sheet**: The reviewer initially thought that the PEI sheet was promising but ultimately found it to be a failure due to unpredictable heat warping. 2. **Red Silicone Sheet with Black BuildTak Clone**: This combination has been successful for printing small, thin-layered prints. The reviewer believes that the silicone offers some degree of latitude by squashing away from the nozzle, allowing for 0.04mm thick layers to be printed almost without trying. 3. **Yellow Polyimide-Tape-Sticker**: The yellow sheet was found to lift easily and fail to stick PLA well, making it unsuitable for most prints. However, the reviewer thinks it may work well with PET-G. 4. **Combination of SWMAKER Build Surface and Non-Stick Silicone Baking Mat**: This combination was also found to work well, although PLA proved difficult to keep stuck on the surface. Overall, the review highlights the importance of finding the right combination of surfaces for successful 3D printing, particularly when using PLA.