Metallica Taranis Q X7 Gimbal Protector

thingiverse

Gimbal Protector for the Taranis Q X7 as requested on the Rotor Riot Facebook group. Ideally to be printed in TPU. Print Settings: Printer: Hictop i3 Rafts: No Supports: Yes Resolution: .3 Infill: Up to you Notes: I print at 35mm/s, 35 perimeter and 54 infill or slower. Some supports needed, in Cura I set it to 45deg so the supports are just at the base of the gimbal and under the bridge and use lines for support, grid usually ends up too difficult to remove. Post-Printing: Remove the supports and trim where needed. I use a scalpel and forceps to tidy it up. How I Designed This: I used Sketchup for the base model, then Tinkercad to create the hemisphere cutouts on the underneath