Metabee on floor plane

thingiverse

UPDATE: The bed size has been reduced to accommodate the model's stand. This Metabee model is far from perfect, but with the settings shown in the photo, it seems to be printing flawlessly. A horizontal expansion of 0.3 or more is crucial for optimal results. I printed this model using wood filament, which proved challenging. This was my first attempt at printing with wood, so my initial settings were imperfect, resulting in excessive stringing. Some areas of the model require improvement. The weakest section is the knee where the entire model stands, but it still manages to hold its ground. The three models displayed from left to right were printed at temperatures of 195 degrees Celsius for the left, 200 degrees Celsius for the middle, and 205 degrees Celsius for the right. The left model features tree supports still intact, straight from the print bed. In contrast, the middle model has had its supports removed with a trim knife, while the right model has undergone further refinements using a hot knife. Additionally, the skirt is missing but can be easily melted on later. Reminder: Ensure that the Mesh fixes are set as shown and apply a horizontal offset of 0.2 or more for optimal results. I hope you like this design and I'd love to see a photo of your printed model!