MESARC FlatFighter modular motor mount

thingiverse

3D printable version of the plywood motor mount for MESARC foamie. http://www.mesarc.club/ Print each file separately or use the 1-shot to print the entire assembly. Four M3x8 screws hold the motor mount in place, allowing easy removal to access the motor and wires. The holes pattern is 16/19, similar to most 22-size outrunner motors. The motor mount fits SUPPO 2212/6 as well as non-standard patterns like 14/14 for cheap motors found at hobbyking.com. Print Settings: Printer Brand: RepRap Printer Model: Prusa i3 2020 Rafts: No Supports: No Resolution: .2 Infill: 100% Notes: Use 100% infill for added rigidity and print with impact-resistant material like ABS or TPU. No supports are needed when printing the 1-shot assembly with the motor plate facing down. Post-Printing: After printing a few parts, it's best to separate them before mounting to avoid damage. Place the mount in a vise, supporting only the back plate, and strike the vertical sections from the rear/top using a plastic hammer or flat screwdriver. Assemble the parts with screws before applying glue.