Merry X-Wing

cults3d

Every good villain needs a hero! Here to rebel against the Sleigh Fighter is the Merry X-Wing! There are a lot of parts to this print - Many of them have pegs to snap into place, but I would still recommend glue. What you’ll need Body: -Front -Back -Center Peg to connect the two parts - Ribbon Back - Ribbon Top (This is the only piece that can use some supports; it printed for me without supports, but the bottom of the ribbon was pretty ugly) - Mech 1 x stand Wings - 2 x Wing A - 2 x Wing B Engine - 4 x Engine - 4 x Bulbs that thread into the engine Candy Cane - 2 x Candy Cane A - Full - 2 x Candy Cane A - Top Half - 2 x Candy Can A - Bottom Half - 2 x Candy Cane B Full - 2 x Candy Cane B - Top Half - 2 x Candy Can B - Bottom Half Guns: My initial plan was to thread the guns and candy sticks together, but it didn’t work as well as I would like, so I included non-threaded versions too. If your printer is tuned better than mine, the threaded versions will allow you to make changes later. If you use the non-threaded version, you’ll need to glue them together - 2 x Gun A - 2 x Gun B Candy Sticks: - you can make the guns as long as you’d like as long as your print can handle the weight - I put 6 on each gun (24 total) Gun Ends: There are 3 option Gold Ball, Tree, & Present - both threaded and non-threaded - 4 x ends - 4 x M2M Connectors - if you want to remix your own end, the non-threaded hole is 9.4MM Across