Mercury Outboard Throttle Lever Part# 44425

prusaprinters

<p>This is a temporary replacement Lever Throttle for an outboard motor. (Mercury Part# 44425) Apparently this is a common part to break resulting in no throttle from your outboard.</p> <p>I made this as a temporary fix to get me back on the water while I wait for the replacement piece that I had to order. (If I were to use it for longer periods of time I'd probably put a sleeve over the screw threads to avoid wear of the mating throttle linkage.)</p> <p>I tried to beef it up a bit from the original one and I used a 6mm x 35mm? (give or take a few mm's?) bolt I had laying around as the post so it would stronger than trying to print that. (I did tap the hole in the print prior to inserting the screw.)</p> <p>I printed this in ABS at 90% infill and only plan on using it temporarily until I get the replacement but so far it's worked perfect and will be worth keeping in the boat as a extra.</p> <p>Anyway.... It's a long shot posting this as to if anyone finds it useful but I tried searching for one (with no luck) before designing this so maybe this will save someones day out on the water too.</p> <hr/> <p>If you have any questions or problems with the files or fitment of the parts just let me know and I will try to fix them.</p> <p><strong>Remember to tip your ~~waiters~~ designers if you like the service.... thanks for looking</strong></p> <h3>Print Settings</h3> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>No</p></div> <p><strong>Resolution:</strong></p> <p>.20</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>90%</p></div> <p><strong>Notes:</strong></p> <p>Tap hole for 6mm screw.</p> </p></p> Category: Sport & Outdoors