MendelMax 2.0 BLTouch Mount

thingiverse

Mounting the BLTouch probe on the MendelMax 2 requires a few simple steps. First, locate the M3 socket on the bed plate of the MendelMax 2 and screw it into place using an M3 screwdriver. Next, take the BLTouch probe housing and attach it to the M3 socket using an M3 screw. Now, connect the wires from the BLTouch probe to the MendelMax 2's electronics. The red wire should be connected to the +5V power pin on the board, while the black wire should be connected to the GND pin. Finally, plug the BLTouch probe into the MendelMax 2's controller and configure the settings in your slicing software.