Mendel LCD Smart Display Controller Mount

prusaprinters

<p>This will allow for mounting the LCD smart controller module to the front of a Sells Mendel.</p> <p>The supports snap onto the top front M8 rod and then tie bands are used to secure it to the lower one.</p> <p>Two small m3 screws are needed to secure the cover to the board after the supports are slid onto the circuit board. Don't forget to remove the small support pieces of plastic underneath the tab which snaps the board in place on the cover before assembling.</p> <p>This was based on the design from the prusa i3 mk2 lcd controller mount. The cover was adjusted for the support distance and the supports were design to allow mounting onto the Sells Mendel.</p> Category: 3D Printer Parts