Megatronics 2.0 Fan Holder and Mount for Orca v0.2

thingiverse

This holder has two parts: a base plate and a top plate that holds a fan. The base plate mounts on your printer with four M3 20mm screws, while the top plate attaches to the base plate with four M4 40mm screws. Short spacers go under the base plate, long spacers between it and the fan holder. The design is adaptable for an Orca v0.2 but can be modified for other printers. An 80mm fan provides cooling while maintaining low noise levels due to its open design allowing good air flow. To assemble, print all parts - base plate, fan holder, short and long spacers, and the fan grill. Mount the base plate on your printer with four M3 20mm screws and short spacers. Attach the fan and grill to the top plate with four M4 40mm screws. Place the Megatronics V2.0 board on the base plate, then fasten the top plate with long spacers and four M3 40mm screws. However, note that mounting the fan may obstruct access to the terminal screws for thermocouple connector or endstop cables connection.