Megatron G1 Scope and Silencer

thingiverse

Howdy all, I was inspired by Korbanos scope, and ended up redoing it with the extra detail and proportions to more suit the toy. I think the only parts I didn't change was the hex design and the part on top, but pretty much skinned it and played around till I was satisfied =-) After being satisfied with the scope(which is attached to an original g1 megs), I ended up making the silencer as well. I may or may not make the stock in the future. Hopefully this will help out someone else and inspire them as well! Just used my normal print settings nothing fancy, but I did make line width the .56 on my .4 nozzle just like Korbano had, for faster printing. Of note, I made the inside of the silence a smaller diameter that grabs the end of the megatron barrel just nicely, not too tight, or too loose, just be careful when putting on that you dont get stuck, i dont want you to wreck your toy ! I also printed it slow and upright, as I have the cr10s which allows high prints, using a brim and regular supports Please enjoy =-) Sam