MeGaTroN Cooler Fanduct Tevo Tarantula w BLTouch Remix

thingiverse

Update 9/25/2017: Corrected the height of the BLTouch mount issue.\r\nIf you printed the original, use a 5mm spacer to correct the z-height of the sensor.\r\n\r\nOffsets for the firmware I'm currently using are as follows:\r\n\r\nX -34\r\nY -5\r\nZ-offset -1.20 (this is what I've worked out for mine, but each one is different, so please go through the full process to find your z-offset.\r\n\r\nI loved this design by Paul0 and needed a BLTouch mount. I remixed it in TinkerCad using the original MeGaTroN Fan duct and the original BLTouch mount, then merged them together. When installed, the lowest point of the fan ducts should be about the same as the pin on the BLTouch when it's in stored state. I'll post offsets as soon as I have it installed on my Tarantula.\r\n\r\nNo supports are needed to print.