Megaman bottle opener

youmagine

This is a straightforward bottle opener that can latch onto a key ring. The figure depicts the shooting pose from the Megaman sprite sheet, augmented with additional material to secure the bottle cap. A fill density of at least 50% is advised. Unfortunately, my initial print collapsed when I used a fill density of only 19%. I printed this object on a printrbot play with a .4mm nozzle and grey PLA at 208 degrees Celsius. The printing surface was prepared using painters tape and TRESsemme extra hold spray adhesive, which kept the object firmly attached to the plate. I printed this model standing upright with supports because the details are identical on both sides and are subtle enough that I didn't want to scrape off one side's brim. This is my first attempt at opening a beer bottle using this tool, and it fails miserably - 19% infill is woefully inadequate. The design will soon be updated with additional support features.