Mega-S 10x10 drag chain mount remix

cults3d

UPDATE 5/28/202: After using the mounts for a few days the chain started sagging. I made the connections thicker and added support to both of them. While measuring I also noticed the hot end side was actually too skinny. The chain is 15mm tall, and the connection was only 13mm so it was bending the tabs outwards, no wonder i had such an issue getting it in. I edited that, added an inner support and thickened the ends. On the extruder side I also adjusted the size for the chain width since it was too wobbly when snapped in, made the male pegs deeper, added a support to the outside end, and the ends a tad thicker. Also added two holes to add a ziptie to pull the wires away from the bowden tube, it was right against it before. I printed the extruder one flat "triangle" side with zip tie holes down, and the hot end side with the chain connection facing up. I liked the 10x10 chain for the X-axis PollyPolz made but the hot end side snapped when I tried installing it on the chain, and again the second time I printed it. I noticed there was no fillets on the inside 90 degree angles which will strengthen it up so I added them.