Mega Construx Scale 80s Cartoon Castle

thingiverse

Finally complete after two years of on-again off-again progress! Castle exterior is a scaled up remix of Castle PiSkull ( https://www.thingiverse.com/thing:2960209 ). The throne is a remix of Fern528's ( https://www.thingiverse.com/thing:4068193 ), with some modifications to the base. This one probably goes a lot smoother if you have a large print bed. I do not... so the front and rear halves had to be sliced up into smaller sections. I've included files for both full front/rear halves and sliced up versions. I used PLA Gloop to assemble the sliced sections, then used a 3d pen to weld the seams and gaps. The hinges for the front and rear halves use a 20mm M3 screw with nut for a pin. Trap door, elevator and drawbridge are fully functional. Some assembly and super glue required. I have printed and assembled this, so I can confirm it works. That said, it took a lot of time, patience, trial and error, and general muttering of bad words.