Mega Anti-Tangle Spool Holder V130%

thingiverse

This is the three parts I modified to achieve a 130% version of the Amazing Mega Anti-Tangle Spool holder from Graham01. With this version you can hold two and three kilogram spools. All other parts are the same, but only printed in 130% size. As extra parts you will need eight ball bearings, eight screws with diameters of four millimeters and lengths around twenty millimeters, twenty-four bolts, and eight rings for these screws. The diameter of the bolt should be seven millimeters to fit into the center hole of the ball bearing. As you can see in the picture, you simply place the screw into the hole, then screw two bolts in place, put the ball bearing on it, put the ring, and finish with the last screw. This will keep the ball bearing firmly in place. Once again, thanks to Graham01 for his initial work.