Medieval Dice Tower Flag [Remix]

thingiverse

I thought a medieval flag would perfectly complement my medieval dice tower, which is already a work of art. 100% cooling from layer 52 (0.2mm layer height) is essential for achieving the desired effect. I printed it on my Ender-2 at 80mm/sec and was blown away by the results. <h2>Print Settings</h2> Infill: 100% Layer Height: 0.2mm Support: None Raft: Yes Print Time: Approximately 0.5 hours I used high-quality Sunlu PLA filament, available at https://amzn.to/2GijM3F. For my CR-10, I swear by the blue tape found at http://amzn.to/2zXjJGu. It's incredibly sticky and comes off without leaving any residue. <h3>Extra Tip</h3> If you're looking for a glossy finish, try using kapton tape! It's available in 200mm rolls at http://amzn.to/2nPggqi. The results are simply stunning. Have fun printing your own medieval flag and enjoy the process!