Medication Reminder Chart

prusaprinters

This is a design for a medication Reminder Chart. inspired by the Household Task Planner by Nils Kal - Linked Down Below. Mainly would be used to keep track of when someone takes a scheduled medication. For this print, there is no MMU required all the color changes can be done layer-based by a filament swap.Assembly:Print out the provided .3mf files - The color change layers are listed down below, you can use any colors you would like.The sliders fit in the slots in the main body, you may use as many or as few as needed for one's needs. (print only as many sliders needed for the time medication is taken - if you don't need sliders for the evening, for example, print less)The front faceplate will fit right over top, fitting snugly into the main body. You may need to use a bit of force for it to fit down.Hang using 2 screws and the built-in screw holes. - It may be easier to mark the screw holes with the main body before you close itIf needed re-open by flexing the body gently.Disclaimer:The minimum bed size required to print this model is 25x15 cm. if you need the split version for a smaller print bed, Please leave a comment and I will post those files.If someone would like a modified version, some adjustments, or if you find an issue, please leave a comment I appreciate the Feedback!Print instructionsThis print does not require any supports anywhere. The color changes are purely layer-based so it does not require any MMU. You can print in any color you would like.Color Changes: based on a 0.2mm layer Hight-Faceplate:-Color change at 1.8mm - color on the lettering - Black in photo-Sliders:-First color change at 1.2mm - color in the lettering - White in the photo-Second color change at 1.8mm - color for the "Yes" - Green in the photo-Third color change at 2.6mm - color for the "No" - Red in the photo-Last color change at 4.4mm - color for the slider cap - White in the photo-Back-plate:-No color changes are needed