Media player clamp for TV mounting

thingiverse

This is a mounting device to secure your small media player (Western Digital or Raspberry Pi) to the bottom of the TV, creating a sleek and cohesive look that eliminates the cable's visible presence. Before assembly, inspect the back of your TV to determine if there's a small ledge located near the bottom edge. If this ledge is too large, you might need to modify the design. The clamp will latch onto this shelf and firmly hold the WD (or any other media streamer) in place against the TV. Refer to the provided photos for visual guidance. When finalizing assembly, tighten the bolt just enough to prevent it from slipping, but not so much that it becomes over-tightened. Note: - The bolt's dimensions are designed to ensure a smooth fit on the thread with minimal friction and play. - During printing, position the bolt vertically, allowing its head to rest on the print bed for optimal results. - Although the full design of the bolt is quite long, you may not need the entire length; simply abort your print when it reaches the required size. Leaving the file intact ensures that users with different needs can still benefit from the design. - The large hole in the clamp's back panel provides easy access to ports (HDMI, etc.). - The big hole in the base serves as a ventilation and cooling channel for optimal airflow. - Remove the small triangular supports under the overhang after printing and clean up any excess material with a sharp knife. - Slice the design in draft mode (0.2 mm) without using supports; breakaway supports are integrated into the design, eliminating the need for separate supports during printing.