Mechanical Toilet Paper Holder

cults3d

A unique toilet paper roll holder. Easily add and remove rolls. Insert the roll from underneath, then once the two ends are aligned with the sides of the roll, let go or pull down, the roll drops into place. Remove old roll simply by lifting up. Alternatively, you can rotate one side 90 degrees, drop the roll into it, then slowly lower it while raising the other side until it meets the roll then let go. Prints in one piece! No assembly required. This model has an internal rotating mechanism. Print with opposite of the screw hole side facing down (the side facing you in the photo). Uses #5 screws. Spacing requirements between installations will vary. Can also be used for other purposes such as paper towels, aluminum foil, etc. Note: Added a revised version that should be a bit more sturdy. Print solid for best results