Measuring Cups

thingiverse

These cups are top-notch measuring cups on Thingiverse today, so enjoy using them! The capacity is calculated with a 5-20ml buffer to prevent overflowing - this value will change based on your settings and print quality. Make sure you read the "print settings" carefully, as they're crucial for achieving great results; if you don't, your cups won't turn out looking good. Also, don't forget to click Like/Made if this has been helpful to you! Note: These cups should not be put in the dishwasher - heat can cause them to deform, at least when printed with PLA. Print Settings: Printer Brand: RepRap Printer: Anastasia Rafts: Any setting is fine Supports: Yes Resolution: 0.2mm for best results Infill: 20-30% works well Notes: Important Note: You must set the support values in Slic3r to print these cups correctly; I've tested other settings with PLA, and this is the only one that gives a nice result. Overhang threshold: 0 degrees Enforce support: 0 degrees Contact Z distance: 0.05mm Pattern: Rectilinear Pattern spacing: 1mm Pattern angle: 0 degrees Interface layers: 1 layer Interface pattern spacing: 0mm Post-Printing: 1. Remove the support - it's very easy to do. 2. Test for leaks. 3. Give them a good cleaning. 4. Enjoy using your new measuring cups!