Meanwell LRS-100 Full Cover

prusaprinters

<p>I needed a more cat-safe cover for my Meanwell LRS-100 power-supply which I use to power my ambient light behind the TV. Since the cats like to stroll there, using it without any cover was a no-go, so I created this.</p><p><strong>Print settings:</strong></p><figure class="table"><table><tbody><tr><td>Nozzle:</td><td>0.4 mm</td></tr><tr><td>Layer-Height:</td><td>0.3 mm</td></tr><tr><td>Filament:</td><td>PETG</td></tr><tr><td>Infill:</td><td>10%</td></tr><tr><td>Brim:</td><td>No</td></tr><tr><td>Supports:</td><td>Yes (enforcers)</td></tr></tbody></table></figure><p><strong>Notes:</strong></p><ul><li>Place support enforcers below the latch on the one side and the two round bolts on the other side.</li><li>It needs a bit of fiddling to fit on the PSU nicely, but once it's in place, it will stay there.<br>The sides can and have to be bend a bit to get it in place and lock it to the PSU, so don't worry to bend them.</li><li>At one sides there are screw holes that match the ones in the PSU, just in case you should need them.<br>You can also use these to check if your cover is aligned correctly.</li></ul>