Mean Well LRS-350-12 mounting bracket for Alunar / Infitary M508

thingiverse

A Custom Mounting Bracket for the Mean Well LRS-350-12 Power Supply Designed Specifically for the Alunar / Infitary M-508 Printer, with Potential Compatibility for Other Models. This mounting bracket fits snugly onto the Alunar / Infitary M-508 printer and may also work on other models if the mounting holes in the frame align properly. The bottom holes are spaced 85mm center-to-center, while the top hole is positioned 126mm from the bottom hole's center point. The mounting bracket comes with a removable cover for the screw terminals, which can be easily attached using M4-6 screws for the top and M4-10 screws with an additional M4 washer for the bottom. The bracket itself requires the following hardware: * Two M3-12 screws for attaching the assembly to the printer * Three M3 nuts for securing the assembly in place To install the power supply, follow these steps: 1. Place three M3 nuts into the cutouts on the bracket. 2. Position the power supply within the bracket, ensuring it holds the nuts securely in place. 3. Use the M4 screws to attach the power supply to the bracket. If using the cover, insert longer M4-10 screws with a washer near the screw terminals and keep them loose for now. 4. Mount the assembly to the printer by inserting three M3-12 screws from inside the acrylic and into the M3 nuts on the bracket. 5. Connect wiring to the screw terminals as usual. 6. Slide the cover under the screws and tighten them securely. Please note that the screw terminal cover does not provide child-resistant protection or electrocution safety, so be cautious when handling exposed power supplies.