Meade ETX-90 RA Canon Camera Mount

thingiverse

BEFORE YOU PRINT: 1. Only the ring needs support, specifically for the dovetail overhang; refer to pictures for optimal print orientation. 2. I had to enlarge the original Arca-Swiss clamp design because it was too small for my Canon mount; I'm unsure if this modification is standard practice. 3. You'll need to apply glue to secure the base to the ring, as the fit isn't very snug. 4. I highly recommend using PTEG .20 at 100% infill for added strength and durability. 5. You will require three M6 bolts and nuts. AFTER YOU PRINT: Apply thin rubber or foam to the inside of the ring to prevent slippage, and avoid overtightening, which could damage your tube.