Mazda Spare Part MZTK49-68-865 Boot Clip Holder for CX-30 and similar

thingiverse

This is a clone of Mazda Spare Part MZTK49-68-865. I needed it as after performing a dashcam installation on my CX-30 in the dark, I lost some of the clips that hold the rubber seal to protect the internals of my boot/cargo bay/trunk door. I've compared the resulting print with a digital calliper and I can't find any variation from the original, the only slight alteration I had to make for printing was the fillet on the head of the part needed to be slightly lower than the original so that there was enough surface area to adhere to the print bed. I recommend printing it head down (the orientation of the file when loaded into Cura), with 100% infill for strength as the part is tiny and otherwise might break if installed incorrectly. I also recommend printing with supports (overhead angle 45 degrees) and cleaning up the excess later. For my car, the originals of these clips are black. In the photos I've printed them in white as that's the only filament I have left. I'll reprint them in black at a better resolution when my new filament arrives, the photos are at 0.2mm. For my application, these parts are used internally. Please note that if your application is external / exposed to UV, PLA might not be suitable.