Maytag Performa Washer Water Spout Replacement (Water Inlet WP22001304)

prusaprinters

The original from Maytag is a flimsy two piece design. Mine was ripped off during an oversized load.This model is one solid piece with extra reinforcement. It's not pretty but I needed something fast and this works just as good, if not, better than the original. The front lip does slope downward just like the original. This gives you that nice wide water wall effect. From what I've read elsewhere, this is compatible with some whirlpool machines as well. In fact, the original part appears to be made by whirlpool.My Print Settings:Nozzle: 0.6Layer Height: 0.2Infill: 20%Supports: Yes - Tree SupportsAdhesion: BrimFilament Type: PLA+Printed with the spout pointing up.Important Note:The gcode file has supports on the lip of the water outlet. This probably isn't needed due to the lip curving over ontop of itself. If your printer is good with curved overhangs then I would forget supports here. However, supports are needed on the wall where the hose gets attached to the inlet. Unfortunately, there is no way around that.If you're looking for the original part, just google: Part #WP22001304