MaxMicron Dual E3D_V6 Mount

thingiverse

Here is the Mount I've been using on My MaxMicron Aluminum Dual Extruder. I Built this Mount to work seamlessly with a BLTouch probe, but I Also included an Option for a 12mm inductive sensor. I'm Still searching for the perfect pin to use for the servo output on the OEM control board. Below is a list of the Hardware that I Used: three M3 x 12mm screws with standard Nuts for the clamp. Two M3 X 8mm Screws with Lock nuts for the Air Ducts. Two M3 X 24mm Screws With Lock nuts for the fans. Four M3 X 12mm Screws with lock nuts for mounting to the carrage. One M3 X 24mm Screw with Lock nuts for the Adjuster lock One M3 X 5mm Screw for the Inductive sensor mount if you use it.