Mavic Pro Spring Loaded Adjustable Tablet / Phone Holder

thingiverse

Large adjustable tablet or phone holders are designed to fit perfectly with the DJI Mavic Pro RC controller. These holders come in two sizes, both with and without a notch that accommodates the phone connector installed on the controller. To complete this project, you will need a properly sized 1/4-inch diameter extension spring. I purchased a six-inch spring and clipped it to achieve the desired tension. You'll also require one 1/4 x 20 x 1 1/2 socket head bolt, nut, and washer. If using the knob with the bolt, insert the bolt into the knob with some medium CA to secure it in place. Additionally, a couple of small nails or rivets will be needed to hold the spring in position. I used rivets, which I then trimmed off flush. A small dab of medium CA can be applied to the ends of the pins holding the spring to prevent them from coming loose. The print orientation for this project is identical to the pictures provided. To ensure strength, I printed with a layer height of 0.35mm and 100% infill, with no supports required anywhere.