Mavic Pro Camera Mount

thingiverse

Updated April 22 , 2019 Just added version 13 of this camera mount. Its a little longer and separate the camera hole from the hole used for the power button. Also made it a little stronger over the hole that clamp around the battery release buttons .\r\n\r\nThought I would try and make a secondary camera holder to go on top of my Mavic Pro. It sits on top of the battery , and should not interfere with the GPS signal . \r\nI made a hole for the power button and the side brackets are for the people that are a little leary about putting a camera on top without better support. I would use a rubber band to go around the Mavic ( being careful not to go over the downward facing sensors on the bottom of the Mavic) . This should ease pilots minds a bit.\r\nI also included a spot to put a 1/4 Hot Shoe Mount through the bottom of the plate as shown in the main picture. You could probably use a Gear 360 Camera with this , or GoPro mount .\r\n\r\nOverall the mount is thicker and fits snugger then some of the other ones you see on here.\r\nI used this as my starting point . https://www.thingiverse.com/thing:2137716\r\n\r\nI printed in PLA and to be safe at 100 percent infill and I added supports around the brackets and the windows for the battery release buttons .\r\n\r\nUPDATE APRIL 8, 2019 . Just uploaded my latest VERSION 8 and Version 10 of this print. Made side walls thicker . Version 10 , I made it easier to print , and it will be more flat across the top of the Mavic , instead of curved . Sorry about how rough it looks , but I am only using Tinkercad to make my adjustments.\r\n\r\nP.S. Yes I know my prints look bad by the area of the supports. Still have'nt mastered the support setting. Biggest reason why I try to make all my things without supports needed.\r\n\r\nUSE AT OWN RISK!!!