Maverick REV-6 cylinder

thingiverse

These are the essential components required to assemble the cylinder of a Maverick REV-6 nerf blaster, which necessitates some adhesion and assembly. The Maverick's cylinder is significantly more intricate than its successors' streamlined, one-piece cylinders. In addition to the printed parts, you will need an 11.5cm long metal rod with a diameter of 2.5mm, a compact compression spring, two 1cm long x 2mm thick screws, and six 3cm long x 3mm thick screws. Dart pegs are not included; obtain them here: https://www.thingiverse.com/thing:546629. Air restrictors are also not included. It is highly recommended to add padding to the plunger head instead. A complete replacement cylinder requires printing each part except for the "Rod_end" piece, which necessitates two pieces (one for each end of the rod). Two additional 4mm long x 2mm thick screws and two washers are also required. Those who wish to create a double- or triple-Maverick mod (like https://www.thingiverse.com/thing:1529446 or https://www.thingiverse.com/thing:508503) do not need to print the pieces "Barrel_side_front," "Barrel_side_rear," or "Barrel_spacer." The piece "Barrel_case" is optional but highly recommended, as the bottom plate screws into it; however, if you're aiming for a cosmetic "minigun" look, you won't need to use it. If not used, some extra adhesion will be necessary. On the other hand, three of the long screws can be omitted.