MatterHackers CR-10 Door Handle

prusaprinters

<p>This does not need much in the way of infill (I used 5%), and it prints in under an hour.<br><br>The pictures I posted are of my prototype, and used screws I had laying around. With low infill and self-tapping type screws, you can go straight into the PLA (or whatever material you're using).</p><p>I have included the STEP file so that you can customize the holes to your needs. Then just separate the top from the bottom and export them to STL.<br><br>With the current setup, the door stays closed fairly tightly, without being under pressure, but also without leaving too much air gap.<br><br>I do recommend at least four top and bottom shells. &nbsp;I had two on the prototype and you can see a little bit of underextrusion (partially from the print being done at high speed).<br><br>&nbsp;</p>