Mask Vent Washers

thingiverse

I have this mask that I bought off of Amazon. It comes with an inner filter that makes it much more difficult to breath, so I took out the inner filter. I found that without the sturdiness of the inner filter, the side vents kept popping out. After almost losing the vents on several occasions, I created these washers to prevent the vents from sliding out of the fabric of the mask. The washers work great and allow the two pieces of the vent to snap into place. The outer washers are low profile and barely noticeable. It's a very easy print that takes about half an hour for two sets of prints. I separated the prints into two files. This way they can be sliced and printed together, or as a single if needed.