Mash Up Fan Duct

thingiverse

this is a mash up of two different fan ducts, it has a 2 degree pitch on the mounting plate so the fan will sit flush against the print head. You must use bridge settings in your slicer or the ducts will not form properly. I now have a Version 2.0, it's a little more streamlined and less prone to warping if using PLA. The upright is now thicker on the 2.0 version, so only the long screws will work, I have them in the two bottom holes and it works fine. Otherwise you have to get two more longer screws if you want to use all four holes.