Martian 2 GoPro (20 degree or 35) - Semi universal

thingiverse

If you can't print this, consider ordering it through my 3DHub at: http://3dhubs.com/service/8Bit. This is a Martian 2 HD box camera (Gopro, Runcam 3, and I think the Foxeer box is similar size too). The first design's tolerances to keep the camera inside were not enough, and it was a little loose, but fit well. I have increased the top and bottom lips and the sides, and reversed my original internal chamfer to be an external chamfer to help get the camera in, while increasing retention. I have added zip tie slots for added strength to hold it to your frame as well as the ability to move it between frames, and potentially only screw in two of the screws, and zip tie it down. This design is very light, but still provides good protection for the camera glass. There are 20-degree and 35-degree versions available. I would highly recommend printing right side up for best layer strength for the screws. Print it with supports. _________________________________________________ If you're going to order the part from someone, consider ordering it from my 3D hub at the link below: https://www.3dhubs.com/service/163675. Find all my designs with #8BitFPV