Martian 2 220mm Lightbar Buzzer Receiver holder

thingiverse

I designed this lightbar holder with a receiver holder to work seamlessly with the Matek WS2812B Led Board and d4r receiver, ensuring a secure fit around the rear posts. I secured the design by applying double-sided tape between the holder and frame, then tightening it further with an elastic tie. You will need to drill your own holes for the lightbar wires; trying to print in the hole can result in a less-than-ideal finish, so use a dremel for optimal results. To ensure proper fitment, center the middle of the two holes at exactly 32mm apart. For printing, I used my Davinci XyZ with the following settings: layer height set to 0.2mm and infill percentage at 15%. Before slicing, take a closer look at your print to adjust settings as needed; I made a few tweaks to get it just right.