Marlin 1.1.0-RC7 for Sunhokey Prusa i3 2015

thingiverse

I upgraded my Sunhokey Prusa i3 2015, equipped with an MKS Gen v1.1 board, by installing the latest Marlin firmware version 1.1.0 RC7 from GitHub, where it was officially released on July 31, 2016. I optimized this firmware for my machine and discovered that most people would find X and Y steps suitable, but Z and E-steps may differ significantly. So far, the new firmware is working exceptionally well, providing noticeable improvements in motion - whether due to the firmware itself or its configuration, the difference is undeniable and not a mere illusion. I recently printed a small nut/bolt item at 0.1mm resolution with impressive results. However, as I am not an expert in firmware customization, any suggestions for further tweaks are welcome.