Mario Themed Reptile Hide

thingiverse

## Information ## ### Description ### This is a mario themed reptile hide intended for a terrarium. Included are models for a mario warp pipe with 4 lower exits and a staircase of standard block tiles found on 1-1 and other levels. The warp pipe and the block staircase connect to eachother through the circular openings on each model. ### Scaling ### There are two sets of models included, one with thicker walls and one with thin walls. The thin wall model is intended to conserve filament and print at 100% scale for larger critters. These were the models I used for my terrarium and lizard. The thicker wall models can be scaled down safely (~50% lowest recommended) for smaller critters and still retain structural integrity. ### Warp Pipe Cap ### Included is a model for a cap to be used with the lower warp pipe exits in case there are some left unconnected and your critter prefers some privacy. ## Print Settings ## ### Infill ### I recommend using 5-10% infill if you want to conserve filament. I used 5%. ### Supports ### Supports should be used for both the warp pipe and block staircase. I used 5 degree overhang for the block staircases and 10 degree overhang for the warp pipe. ### Brim/Raft ### I used a 3mm brim to ensure my model would not move off the print bed 20 hours in.