Mario Question Mark Block Amiibo Stand (Customizable)

prusaprinters

<p>This is my attempt to create a Mario question mark block type Amiibo stand.</p> <p>It prints easy without any supports. Use 0.2mm layer height and 7% infill with a triangular infill and 3 walls to make it beefy.</p> <p>The question mark object needs to be printed four times and should be white or any other color you like. It will be glued into the cube.</p> <p>In your slicer you may notice a very thin line between the question mark and the dot. This was required to convince FreeCAD to create a single object. It should not appear in the final print unless you have "thin walls" enabled. Even than it would only be a single line and easy to remove.</p> <p>Print the block in yellow, orange or some other yellowish kind of color and the question mark in some light color. It will fit right in and just needs a little glue. Red/White and Blue/White looks beautiful, but are less following the official Mario style.</p> <p>As always the FreeCAD source file is included.</p> <p>Happy Printing</p> <h3> Print Settings</h3> <p><strong>Printer:</strong></p> <p>TronXY X5</p> <p><p class="detail-setting rafts"><strong>Rafts: </strong> <div><p>No</p></div><strong>Supports:</strong></p> <p>No</p> <p><p class="detail-setting resolution"><strong>Resolution: </strong> <div><p>0.2</p></div><strong>Infill:</strong></p> <p>7%</p> <p><strong>Filament:</strong> Noyes PLA Bright Yellow, White <br/> <p class="detail-setting notes"><strong>Notes: </strong> </p><div><p>Make sure you print at least 3 walls. That way the block gets sturdy without a ton of infill.</p> There is no support needed. Any printer should be able to bridge the small overhand on the question mark groove.</div></p> <p>The question mark elements need to be glued in. Even a three year old can do the puzzle. :D</p> </p></p> Category: Sculptures