Mario Kart Tournament Trophy

thingiverse

Cleaned the trophy model so it can be printed hollow without any issues. A word of caution: printing this model can get quite messy, so be prepared for that. It prints exceptionally well on resin printers with a wall width between 1.5 and 2mm - 1mm is also great but may lead to print failure due to its thinness. After the print, manually add some glitter through holes in the bottom (this feature is not included in the model; I recommend using MeshMixer to hollow out the model and create some holes). To give it a nice weight, fill the insides with mineral oil and seal off the openings. The scales used for the image are 100% gold, 85% silver, and 75% bronze - all three have a 1mm wall thickness. However, I had to manually repair some holes from the print, so it's recommended to use a thicker wall or longer layer times to avoid similar problems.