Marble Run Kit

prusaprinters

This is a “Step” style marble run in the form of a kit, each sheet of parts takes around 4 hours to print and the model has a total 3 sheets of parts.All parts of this model require No Supports.File names:Small Parts.stl -These are the smaller parts of the marble run, this part of the model has many parts, be sure to have good bed adhesion when printing these parts!Panels1.stl -These are the larger parts of the marble run, used for the outside of the marble run.Panels2.stl -These are also some of the larger parts of the marble run.Drawer.stl -This is the drawer for the marbles, this part is not necessary, but gives you a easily accessible place to put the marbles, which fits in the underside of the marble run, as seen in photo.Note: if you wish to print all the parts separately, right click the model in Prusa Slicer and select split-into objects:MarblesThe marbles I used were ¼"/6.35mm diameterSpecific link to the marbles I used:  Amazon.ca-¼" steel balls 100 pack Assembly:Use provided photos to assemble, if many people have trouble with the assembly, I can make instructions. Some photos to help with the assembly:The cam shaft should look like this:All parts required for assembly:-Use the pins(3 -one extra) to keep the cams(6) from sliding around-Use the thicker cam-washer on the side without the crank Any questions with the assembly feel free to message me! Happy Printing! Model suggestions?Email me: calinolsen@gmail.com