Manual Bed Leveling Hack for Monoprice Select Mini MPSM

thingiverse

Thanks to Adam Hutton for inspiration (as I actually never printed his design but have a look) https://www.thingiverse.com/thing:3280396 There is very good documentation. Created by mistake, trying to design a MBL for the V3/Pro version. This is available here: https://www.thingiverse.com/thing:4652745 -------- This is a slim new design, tested on V2. Flush with the bed, compatible with any part cooling hacks. No Z-height offset. But if you need any offset (ex: glass bed) https://www.thingiverse.com/thing:4624845 No problem with heat bed or insulation material. Printable on the Mini (2 batchs). Reusing orignal screws. You need: - Eight (8) M3 Nuts (dimensions in the design are for 5,5x2,3mm) Installation procedure: https://www.youtube.com/watch?v=BVZFff9CJkE See in action: https://www.youtube.com/watch?v=tzfWYXsF1oE Actual part printed in ASA, but should be good in PETG and Ok with PLA. Regular thumbwheel is flush with the front of the black bed plate. Big thumbwheel is easier to use. Thank you for your feedback. ----- Thumbwheel slides from the nut?: Added a thicker thumbwheel so the nut will stop before falling. You can put a bit of crazy glue too.