Manta M8P +noctua 120mm fan + pi3b+ integration

thingiverse

Because the CB1 adapter board is curently not working and is being replaced by bigtreetech, untill that arrives i adapted the original Bigtreetech voron DIN rail mount for the Manta M8p to attach together with a pi 3B+ This has been tested and working. The fan cools the stepper drivers and also the Pi . Just make sure you dont make a spider nest with the wiring and allow for airflow to reach the Pi. I attached the F3D file so you can modify the design at your own free will. The 2 holes underneath the fan mount are for a HDMI to 40 pin GPIO adapter that is used to compress all the extruder wires into one HDMI cable and pass it to a daughterboard on the extruder. ( if you ever used a Biqu BX you will know) I printed this out of PLA because it sits underneath the printer where it doesnt get hot. Make sure you print some taller feet for your voron ( plenty available on thingiverse) to account for the offset of this setup.