Mankati Full Scale XT - E3Dv6 / Vulcano mount

prusaprinters

<p>"To attach the two printed parts i've designed it to use 2 m3x10mm hex cap screws. The holes should be just small enough that the screws can self tap. So please don't over tighten."</p> <p>-The original designer-</p> <p>The ultimaker and Mankati Fullscale XT are almost the same so with a little adjustment on the axle spacing it is useable on the Mankati Fullscale XT.</p> <ol> <li>Print this, all models are to be printed without support</li> <li>Disassemble your printhead</li> <li>Remove red block</li> <li>Put on mount</li> <li>Add your E3D v6 or vulcano head.</li> <li>Add clamp</li> <li>Add fanduct or fanduct BLtouch if you installed a BLtouch</li> </ol> Category: 3D Printers