Mandarin Mince Pie warmer

thingiverse

Warm up your mincemeat pies with just orange peel and olive oil!\nYou'll need:\n4 paperclips\nSmall orange\nMincemeat pie\n3D printed parts (Part 1 & 2)\n\nPrinting Settings\nNote: You don't require any rafts, supports or brims. My model was created using a DaVinci 1.0 printer at 15% infill.\nPost-Printing Instructions\nPrepare paperclips by unfolding and threading them.\n Unfold the four paper clips into thin rods and pass them through Part 1's holes. Fold the clips over onto their corresponding sides to prevent loss of rods.\n Make an orange candle as follows:\n Step 1: Draw a line around the center of the orange, keeping intact the attached stalk end. Remove segments while safeguarding this membrane, which serves as your wick.\n Fill the membrane with a thin layer of olive oil and ensure it is well saturated. Light with a match and be patient – ignition may take some time. Position in a rounded dish made from Part 2.\n Integration & Usage\n Merge Parts 1 and 2 by aligning the supports into slots. Place your mincemeat pie atop and enjoy when warmed up!