Mandalorian Speeder 'latest model' for Vintage Astromech

cults3d

The Mandalorian doesn't like droids driving his speeders but the latest model looked pretty neat. This was speeder was designed with vintage Kenner Droids in mind. Much care has been taken with the design and orientation to ensure the print and assembly is enjoyable. If you are confident in printing it is possible to print without supports although I used a small amount on the chassis side fins and engine face. The Chasis dimensions round up to 192x51x289mm and if that doesn't fit your printer's build envelope the chassis also has a version cut into thirds. Rear, Middle and Front. For the 3 piece chassis there are guild holes on the rear and mid piece that take a 20mm length of filament. I found that after the rear and mid are joined it was easier to insert the side grills followed by the front chassis piece. The rear engines can attach to the engine block using (1.75mm) 20mm filament off-cuts also. The seat is the only piece that I used infill on about 25% with 4 or 5 shells. You will need to print 4 seats.