Maleficent style staff

prusaprinters

<p>This is a staff I made for a show.</p> <p>The body can be drilled to fit whatever size led's you want to fit.</p> <p>The handle holds the battery pack and switch.</p> <p>The body and handle can be screwed together with 3 small screws, recessed holes are in the bottom of the handle. No screw holes are in the body as I'm not sure what size screws will be used , so you'll have to line them up and drill yourself</p> <p>The handle should fit a 1 inch pole.</p> <p>I made the light from a cheap pound/dollar store aluminium torch, I cut the top part off about an inch from the led's, I soldered on wires from the inside of the led to the battery pack and switch to complete the circuit.</p> <p>The torch top is hot glued into the main body.</p> <p>Be careful of polarity or you'll destroy the led's.</p> <p>The torch power switch is re-used and should screw or push fit in the handle as shown.</p> <p>The diffuser should push over torch top and can be printed in whatever colour you like.</p> <p>My staff was printed in gold PLA and is transparent enough to allow the colour of the diffuser to show through.</p> <p>I've added a model for the side button in case you want to make the handle look symmetrical.</p> <p>I have some ideas to improve this a little but it was all done in a week so apologies if I've been vague about anything.</p> <p>The globe I printed at .8mm walls 100% infill the rest 1.2mm walls 20% infill.</p> Category: Costume