MalahitSDR(China clone) Exterior

grabcad

The case of the MalahitSDR clone made in China was difficult to use and not good looking, so we made an exterior.It can be fixed to a camera tripod with a camera screw.Two types were made. One of them has four M3 screw holes for expansion.(ExtA4/B4)Prepare the following items.a.M3/6mm screws and nuts x 2b.1/4 nuts x 1If the switch hole is too small, shave it down to adjust.Use of this case is at your own risk.Deformation of the case, thermal runaway of the equipment, or dropping of the radio due to damage to the camera tripod attachment part may occur.In addition, depending on the output precision of the printer, it may not be possible to assemble it properly.