Makita drils and drivers bit holder

thingiverse

This is a genuine creation - not a remix - crafted from scratch. It draws heavy inspiration from the Gertsen model. I created it because the Gertsen models didn't fit perfectly with my Makita tools, and I wanted to have an option for both left and right side installation. In addition, I believe adding magnets on the bottom is beneficial for holding bits in place. Although they weren't falling out previously, it's more convenient to pick it up when held by a magnet rather than friction. There are two versions available: one without magnets (with slightly smaller bit holes) and another with holes designed for 10x5mm neodymium magnets. Both configurations can be installed on either the left or right side. You can print this design without supports - the upper lip may not look its best, but it's located on the Makita device side and will be completely hidden after installation.