Makita bit holder

thingiverse

Hex bit holder for Makita. There's one out there for $20 on Amazon but I didn't like the orientation.. the bits stick up vertically and seem to get in the way of tossing the drill around. This design focused on tight clearance to battery (no interference) and relatively minimal space. It turned out well. You have to drill the hole for the M4*16ish screw. I've found that drilled holes are more structural because it melts the plastic, and it smooths out the print. But if you have this drill it should be no problem :) Requires 40mm x 10 x 3 neo magnet, and I used construction adhesive and hot glue. 2 part print because I can't print PETG well enough to use supports XD. Also better strength axis Currently works with XDT19Z with no modifications and you might have to take the razor knife to fit the other drills and impact drivers.