Makita Battery Charger Wall Mount

prusaprinters

I got a new makita charger for the holidays, and it did not fit my older model (posted elsewhere).  So, I've created a lightweight charger mount!  This uses your original rubber feet on the brackets!  This can also be mounted to your charger off the wall, then screwed to the wall so the alignment is perfect every time!  You can see that we have enough clearance to fit a screwdriver easily around the charger while mounting it to the wall.  So far no problems.  I printed mine with a 0.8mm nozzle and a big layer height because I wanted them to come out in less than 30 minutes, but if you don't like the layer lines, I think I used 0.55mm layer height, you could wasily just reduce the layer height.  Consider using the infill modifier file to make the part have solid infill for the pegs, as this will ensure proper structural strength.