Makita 18V charger holder for pegboard

prusaprinters

<p>Easy "on and off" Makita 18V battery charger mount. Sized to fit: pegboard (1 inch on center holes), Makita DC18RC or DC18RA -- leg (or "feet" on bottom of charger). Spacing may be different on other Makita charger models. Model DC18RC and DC18RA have feet 153mm on center. I used only the top two legs, replacing (and saving) the rubber feet from the top row. Use M3 x 10mm or 12mm length bolt with each "bolt" (see parts to print). The M3 bolt screws into the model bolt part and expands it a bit to secure inside the Makita charger leg. All can be printed without support, requiring minimal clean up of the hole for the M3 bolt. Two models -- "square" and "rounded"...just for fun. The square version may have a little more strength, but I've never tested that hypothesis. I use both.</p> <h3>Print instructions</h3><p>I used PETG, no support needed (just a bit of clean up for bolt), 3 perimeters, 3 or so top/bottom, and 25% or more infill for strength.</p>